@doublemac I just checked the release notes and you might need v6.1 of the controller instead of v6.0. The latest pre-release firmware post was just updated an hour ago.

@doublemac I use SG2008 switches here which are practically the same. As stated earlier, I don't use switch ACLs because gateway ACLs are easier to set up. The latest Omada v6 controller allows IP...

@doublemac For the switch ACLs to work properly, at a minimum you need to have a switch interface enabled on each VLAN, otherwise everything passes through the switch and on to the gateway for...

@lukass2000 In comparing the two models here, the SG2428P has 2 fans and the SG2428LP is fanless. The SG2428P power supply must be larger as it can supply 250W PoE while the SG2428LP is only designed...

@lukass2000 You might take a look at this thread that was posted some time ago.

@randoman If the switch is being managed by a controller on the management VLAN, there is no need to enable a switch interface on any other VLAN unless you are routing or providing DHCP services with...