I set up my 3 M5 Deco pods with my new ATT fiber modem and disabled the BGW320's wifi. I also did IP Passthrough through the modem interface. I tried to manually input the main Deco's MAC address and

started with a working network consisting of 3 decos in wifi router mode. I want to switch over to an OpenWRT router and use the decos in AP mode. I turn off all the decos and connect the openwrt rout

Hello community, This is probably a duplicated, however I was not able to follow advices in other thread. I have a unoperated switch connected to Deco and then another switch connected to the first sw

Hello all, I've been pretty happy with my Deco M9 Plus for the last 4 years, but now I would like to increase my coverage area (just got out of the military and finally able to settle down in one plac

HI Guys...an extension of my earlier question here Moving to a new house with three Deco M9+ units. Expect to use TP-link AX1500 as the main router/switch to connect with the ISP, and the Deco in AP m

My Internet speed is 600 Mbps, but I only get WiFi at 400Mbps. I already reset the device, no effect. I think M5 is not as good as advertise. Any suggestion?