I'm looking for replacement antennas for the eap225 outdoor AP. What are the type of connectors they use to screw into the main unit? Thanks.

Installed a EAP211 bridge kit and the interface claims the bridge network is working, 630Mbps TX, 571Mbps RX. The problem is that I cannot reach anyting from the client side of the bridge. From the Ma

I’m managing my network with an OC200 + ER7206 + Managed Switch setup. My goal is to access and manage a ZTE router (IP: 10.10.10.254) located in VLAN 10 (subnet 10.10.10.0/24) from my Admin LAN (192.

hi all, i have following setup: Fortigate 60F - Switch Netgear PoE - OC200 with 4 EAP610 connected. Running several tests (mainly speedtest) i ve discovered that after 6/7 times, speed decrease from 3

Morning all, looking through the general information on the gateway ACL page it says an option is available to log traffic. When editing or even adding new gateway ACLs, that log function is not avail

Hi, I have the above gateway with controller duties managed by an onsite OC300. I see some reported CVE issues relating to this model which should be resolved by a firmware update, eg: https://support