Dear TP-Link Omada Team, I am facing an issue with my Omada Software Controller (running with a public IP). When I add any TP-Link switch or AP from a remote location, the devices are not automatica

I'm having RADIUS problems over here. Clients are getting dropped randomly and not re-associated. Also, a whole lot of these: "protocol 0000 is buggy, dev ath14" Here's an example of what happened thi

Hi, The docu for clusters (distributed and hot standby) talk about having any node on the local subnet. Is this a strict requirements? What about having geo cluster, two nodes at the HQ and one other

Hi, I am trying to create a IPSec VPN with a Zscaler DC. The VPN config is fine but it throws a phase 2 error stating "INVALID PROPOSAL" You can see the logs below, these are from Zscaler. I think tha

In the controller logs, the entries appear with a 12 hour timestamp and "am" or "pm". Is there a setting for the controller to use 24 hour time? I can not seem to find it. I read in earlier posts that

Hi everyone, when I add a new device, my gateway (controlled by a OC 200) gives a new IP address from the default VLAN via DHCP to it. So far, so clear. If I then change the IP address to a fixed IP,