Tapo P100 default status ON
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
When power goes down, the default state of the P100 is OFF. I'd like to set the p100 in a way when if a power cut, the default state is ON when power comes back. Is this possible?
Thanks.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Solla-topee Hey! Today everyone received a software update - the auto power on function was never delivered :(
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Solla-topee when release?
- Copy Link
- Report Inappropriate Content
Hello everyone,
Thank you for your feedback and patience! Set the power state of Tapo plug is Now available for some TAPO models.
You could find the latest information about this feature from here:
[Tapo Plug] Set Default State after Power Failure is Now Available （Tapo P100 V1.2 / P110）
https://community.tp-link.com/en/smart-home/forum/topic/275292
Please leave the Hardware version and Country version (UK/ EU etc.) of your device there if you require the same feature, we would record your feedback for further evaluation, thank you for your understanding.
- Copy Link
- Report Inappropriate Content
@Solla-topee Ultimate solution would be if tapo return into it's previous state after power return.
If it was off before then it should stay off, if it was on before then it should turn on again.
I'm using 2 Tapos and I wish that one is on by default (boiler), the other depends on current state (light).
In this case you will satisfied all people wishes.
Can you do that?
- Copy Link
- Report Inappropriate Content
I already received the firmware with this feature, tested and it works! Thanks for earing us Tapo.
Firmware version is 1.4.9
- Copy Link
- Report Inappropriate Content
When this feature(default state) will be available for HW version 1.0?
- Copy Link
- Report Inappropriate Content
Just receive 2 tapo P100 today. After update latest firmware 1.3.4, it still remain off after power cut. Useless and keep in drawer.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 6
Views: 7689
Replies: 34
Voters 5
