Wifi disconnecting
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I'm getting errors on my C510W with bad signal strength and a lot of disconnections. It only seems to have appeared since a recent firmware update to 1.0.8.
I've recently installed an TL-WA855RE AP in my garage which is showing that the camera is connected to it and initially the signal strength was down to -34. Monday night it lost connection at around 2am so I had to reboot it in the morning. This morning the signal strength is at -71 despite still being connected to the same AP right next to it.
Hopefully this can be resolved because I can't have it disconnecting as frequently as it is.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Just rebooted it and the noise has dropped and response to returned.
Before
After
- Copy Link
- Report Inappropriate Content
Hi,
Please check if your range extender and the wireless router use the same SSID.
If so, the camera may connect to the range extender with a good Wi-Fi signal but connect to the router with a bad Wi-Fi signal.
You can try to set the range extender to have a different Wi-Fi name from the router, reset the camera, reconfigure it to connect to the range extender's SSID, and then check if the connection will be stable.
Please note that it's recommended to place the range extender in the middle of the camera and the router rather than next to the camera if you want to extend the router's Wi-Fi to the camera.
Best Regards
- Copy Link
- Report Inappropriate Content
I did originally place the extender in the kitchen but I was still getting lag and noise. Putting it in the garage reduces the noise the best and does have the same SSID
- Copy Link
- Report Inappropriate Content
Hi,
It's suggested to set a different SSID on the range extender from the router so the camera won't switch the connection between the router and the range extender.
And if the camera drops the connection, you can simply verify if the Wi-Fi network of the router and range extender are working.
Best Regards
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Paddy99 It's better to verify if the range extender's 2.4G Wi-Fi is working when the camera does not work if the problem happens again.
- Copy Link
- Report Inappropriate Content
Definitely, just unfortunately a bit difficult when it's in the early hours of the morning when I'm asleep but have been checking when it goes down and I'm awake.
Happpened again overnight on the new firmware between 2-8am but solid again since
- Copy Link
- Report Inappropriate Content
@Paddy99 How do you confirm the camera is disconnected between 2-8 am if hard to verify if the Wi-Fi from the range extender is working?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 503
Replies: 8
Voters 0
No one has voted for it yet.