Not working TAPO c200 after updating
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
My camera not responding after firmware update, camera only showing 4 Red LEDs, powered on,
and nothing else
i have tried reset methods many time but unsuccessful
please advise how to reset without mobile app, because i cannot find my camera in mobile app now
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
You can refer to the link below to factory reset the Tapo camera via the reset button.
How to reset my Tapo camera?
It's suggested to refer to Case 1 in the below instructions to troubleshoot if the problem remains.
What to do if my Tapo Camera gets bricked after a firmware update?
Best Regards
- Copy Link
- Report Inappropriate Content
Hi,
You can refer to the link below to factory reset the Tapo camera via the reset button.
How to reset my Tapo camera?
It's suggested to refer to Case 1 in the below instructions to troubleshoot if the problem remains.
What to do if my Tapo Camera gets bricked after a firmware update?
Best Regards
- Copy Link
- Report Inappropriate Content
@dineshpatel me too same issue
- Copy Link
- Report Inappropriate Content
Hi,
You can refer to the above post to troubleshoot according to your camera's model number and hardware version.
Best Regards
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi,
Can you share a video showing the process thus I can provide the proper suggestion for you?
Usually, after you download the firmware of the Tapo C200 on your computer, there is no problem copying and pasting it to the SD card connected to the PC.
Best Regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 3
Views: 1060
Replies: 6
Voters 1
