Probelm with c520ws after new update?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Probelm with c520ws after new update?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Bear1007

2024-10-07 19:59:25 - last edited Thursday

Posts: 2

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2024-10-07

Probelm with c520ws after new update?

2024-10-07 19:59:25 - last edited Thursday

Tags: #Firmware #Motion Detection

Model: Tapo C520WS

Hardware Version:

Firmware Version: 1.2.9

Does any one have problems with the c520ws camera after update from 1.2.8 to 1.2.9?

My camera does not return back to my configed zero point, after followed some one, or some activity, but insted some way of insted

1 Accepted Solution

Solla-topee

2024-10-09 08:22:11 - last edited Thursday

Posts: 18327

Helpful: 3139

Solutions: 3976

Stories: 11

Registered: 2020-05-19

Re:Probelm with c520ws after new update?-Solution

2024-10-09 08:22:11 - last edited Thursday

@Bear1007

Hi,
Usually, the camera's position where it started tracking the event is the original position. After tracking an event, the camera will return to its original position after 30 seconds if no new events are detected.
Do you mean the camera won't return to the original position after tracking even if no new event is detected and has waited for 30 seconds?

If so, please send me(@Solla-topee) "Forum ID 708692+ camera's MAC address" via a private message.

Best Regards

>> Smart Home: Introduction to Common Smart Action Scenarios for Tapo Cameras >> Tapo Camera Day/Night Mode Selection Guide: Best Settings Recommendations for Different Scenarios >> What should I do if my Tapo camera triggers false detection? >> Enhance Your Tapo App Experience: Introduction to Several Practical Features

Probelm with c520ws after new update?

Probelm with c520ws after new update?

Information

Voters 0

Tags