Tapo C212 not resetting to configure in new house

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Tapo C212 not resetting to configure in new house

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AksAri

2024-11-03 14:05:11 - last edited 2024-11-14 11:14:16

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-11-03

Tapo C212 not resetting to configure in new house

2024-11-03 14:05:11 - last edited 2024-11-14 11:14:16

Tags: #Device Connectivity

I am not able to configure the device to a new house. The led is blinking green and red after a reset, but when i am trying to set up the device, it is showing it is already configured. Even after repeated attempts it is still showing a similar issue.
Is this supposed to be used as a use and throw device or what?

1 Accepted Solution

Solla-topee

2024-11-04 10:49:21 - last edited 2024-11-14 11:14:16

Posts: 18421

Helpful: 3147

Solutions: 4032

Stories: 11

Registered: 2020-05-19

Re:Tapo C212 not resetting to configure in new house-Solution

2024-11-04 10:49:21 - last edited 2024-11-14 11:14:16

@AksAri

Hi,
It's recommended to connect the camera to the router by an ethernet cable, try to configure it by following the instructions on the Tapo app, and then check if it will be configured successfully.
And this thread may help you.
Best Regards

>> Smart Home: Introduction to Common Smart Action Scenarios for Tapo Cameras >> Tapo Camera Day/Night Mode Selection Guide: Best Settings Recommendations for Different Scenarios >> What should I do if my Tapo camera triggers false detection? >> Enhance Your Tapo App Experience: Introduction to Several Practical Features

Tapo C212 not resetting to configure in new house

Tapo C212 not resetting to configure in new house

Information

Voters 0

Tags