Tapo c310 not.working after firmware updatw
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TAPO C310 was set up successfully and stopped working after firmware update. Not responsive to hard reset, no voice command, led light and night lights are all in solid red light. What to do to revert back to older firmware version?
Feb 2024 update
Hello everyone,
If the Tapo C310 camera got a firmware update failure, make sure you have tried to factory reset the camera with the camera powered on, check camera still responds to a factory reset, or if the camera still broadcasts the Tapo_Cam _XXX default SSID, or if the LED flashes amber and green.
If the camera responds to a factory reset and has a flashing amber and green light, you can refer to the instructions below to reconfigure the camera.
How to set up the Tapo camera?
If a factory reset does not help, you can try the suggestions in the thread below.
What to do if my Tapo Camera gets bricked after a firmware update?
If the above steps do not help, please contact the retailer or local support to check the device warranty.
When contacting local support or retailer, you may attach 1. the problem description with device model and hardware version 2. Led status on camera 3. if there was any power outage 4. the proof of purchase and S/N, so they could deal with your case faster.
Best Regards
* I will be marking this post as the 'solution' to this topic for our forum users to find this information easily, thank you for your understanding.*
