Deco
I have setup a 3 node XE5300 in Access Point mode, with the main used being plugged into a Netgear JGS524E gigabit switch, which is then plugged into my external router (a Firewalla Gold). Everything
BackhaulAccess Point Mode
2Helpful
303Views
So after doing much searching and ending up with most threads ending in the same way, (no further response from TP-Link) I decided I had better try to get the problem I'm having solved. I have the X20
Wi-Fi 6EBandwidth Control/QoSVLAN/IPTVAccess Point Mode
0Helpful
204Views
I am trying to figure out if this is a good setup for my needs. I feel it is all a bit complicated. I have a couple of devices in a few different rooms. One room has an internet port from the ISP, a r
VLAN/IPTVAccess Point ModeBackhaul
0Helpful
321Views
Dear, Since I installed my new internet, a fiber point with a speed of 600 down/300 MB up, I haven't been able to reach the contracted speed using the deco m5 anymore (before I used a fiber 300/150).
Access Point ModeBandwidth Control/QoSPort Forwarding
0Helpful
336Views
Setup is this, MAIN deco is hard wired to xfinity router. Second deco is about 100' away, Third deco is 100' away from the 2nd, and about 200' away from main. I would expect after optomizing network a
Access Point Mode
1Helpful
118Views
I would like to request a feature to support multiple virtual SSIDs in AP mode with VLAN tagging for each SSID. This will allow me to connect my IoT devices to a dedicated network and VLAN them off fr
Feature RequestFirmware UpdateAccess Point Mode
By
jacauc
4Helpful
150Views
Deco XE200 Firmware Version : 1.0.0 Build 20220722 Rel. 58229 XE200 HW V1.6 After set up/installation with (1) XE200 as Main, (1) XE200 as satellite w/ existing and previously working fine (1) X5700 M
Access Point ModeWi-Fi 6EXE200 & X60
2Helpful
129Views
Hi Bought the 3 pack DECO X60 mesh system. Able to setup the MAIN Unit and 2nd Deco unit ( this one I plugged in and it automatically got connected to the mesh system). HOWEVER, for the 3rd unit, I pl
Access Point Mode
By
CalvinHobbes
· Latest post 2022-10-05 16:54:43 by
Riley_S
0Helpful
314Views
As above, I've a chance to get a good deal on a 3 pack, but reading online someone has mentioned that powerline backhaul only works when the deck is set in router mode, not as access points.... Now,th
BackhaulAccess Point ModeFirmware Update
0Helpful
214Views
I'm using Deco in AP mode and my setup is as follow: Router --wired--> node1 --wired--> node2. Recently in Deco App the Clients List started temporarily showing (show for a min then disappear for anot
Access Point ModeDeco App
0Helpful
177Views