M9 Deco connection issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
M9 Deco connection issue
M9 Deco connection issue
2020-03-12 16:03:41
Model: Deco M9 Plus  
Hardware Version:
Firmware Version:

Hello everyone. I'm facing an issue where one of the slave deco's keeps losing connection with the main deco. Not so weird as the signal source is only one bar. 

 

However, sometimes the slave deco gets its signal from the other slave deco and everything works much better. No connection drops and much better speed overall. This is what I want!

 

This is sadly temporary as the slave deco eventually seems to want to reconnect with the main deco.

 

Can I somehow force the slave deco to connect to the other slave deco? 

  0      
  0      
#1
Options
1 Reply
Re:M9 Deco connection issue
2020-03-13 21:23:35

@Renzo89 

 

What you can look to do as a alternative is to possibly run a Ethernet cable from one slave to the other.

 

Or look at possibly doing a Ethernet backhaul, where you have a switch connecting to the main Deco and the other two wired to that switch.

  0  
  0  
#2
Options