Home Network Community > Deco > Deco M5 in AP mode: Is it possible to set a static IP for each unit?
< Deco

Deco M5 in AP mode: Is it possible to set a static IP for each unit?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M5 in AP mode: Is it possible to set a static IP for each unit?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco M5 in AP mode: Is it possible to set a static IP for each unit?
Deco M5 in AP mode: Is it possible to set a static IP for each unit?
2020-03-13 20:38:12
Model: Deco M5  
Hardware Version:
Firmware Version: 1.4.2

Hi, I have the Deco M5 with three units / pucks.  I have it configured in AP mode. 

 

The units grabbed their IP addresses from the DHCP server.  Is it possible to set a static IP for each unit?

  0      
 
  0      
 
#1
Options
1 Reply
Re:Deco M5 in AP mode: Is it possible to set a static IP for each unit?
2020-03-13 22:30:37

@Rob_A 

 

While in AP Mode you can not set the static IP for the Deco units. You will need to go into the main router and do the address reservation there. The MAC addresses are below each Deco unit so you can assign them accordingly.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1835

Replies: 1

About Us
Press
Copyright © TP-Link USA Corporation. All rights reserved.