My connection will not negotiate past 100MBPS I have tried directly connecting to the ONT box 10gb port with a CableMatters Cat 6e cable. When I used the ethernet jack on the motherboard both that cab
Windows 11
By
Pejorative
· Latest post 7 hours ago
by Pejorative
0Helpful
31Views
Setup Deco BE63 (US), 3 units, firmware 1.3.5 Build 26071712 Rel. 18941 on all units. Hardware version is not shown in the Deco app. Backhaul: wireless (wired is not possible in this house) SSIDs: mai
RoamingMLOWi-Fi 7Client Devices
By
dave_Lneedshelp
· Latest post 14 hours ago
by dave_Lneedshelp
0Helpful
61Views
Turn Teathet parent control App limit time to 5minutes interval rather than 15mins only.
By
PingL
· Latest post Yesterday
0Helpful
20Views
Hey Everyone, We're excited to share early access to a new pre-release 1.5.1 firmware update for Deco XE75/XE5300/XE75 Pro V1.0. This update builds on the previous pre-release version 1.5.0, which was
OfficialHighlighted ThreadDoH/DoTVPN
0Helpful
53Views
My kids couldn't get to Apple App Store, Music, etc. I turned off the Gambling parental filter and access was restored... seems like an overly broad filtering criteria.
Parental Control
By
UConnJay13
· Latest post Yesterday
0Helpful
32Views
I want to use this device only to provide ethernet access for a device to my existing Wi-Fi network. Can I use the web interface to turn off both extended networks and still have it function in this m
By
brichter
· Latest post Yesterday
0Helpful
35Views
My Deco X60 will not reset to green. It just flashes blue
By
mariop123
· Latest post 19 hours ago
by Solla-topee
0Helpful
36Views
I have a TP-Link 19000 Tri-Band used in a home setting with about 50 devices attached. The devices are connected roughly half/half wireless or wired. The wireless devices connect via 2.4, 5, and 6Ghz
Access Control
By
mash2
· Latest post Thursday
0Helpful
40Views
Hardwired printer. Device isolation on. Can't print from a WiFi connected laptop. Turn isolation off and printing works. Is there a way to protect the network and allow printing from WiFi connected de
By
Pete2023
· Latest post 19 hours ago
by Solla-topee
0Helpful
43Views
Hello, I am new to TP Link routers. I am looking for recommendations on which router to buy. Currently using a Synology router but wanted to see if TP Link would be a good replacement in the near futu
By
guyguy
· Latest post Thursday
0Helpful
47Views
I have a mesh network of three Deco M5 extenders. Each extender is hardwired back to the modem. The extenders are traveling over Cat-8 cable. I have a one gigabyte modem and receive approximately 300
By
AttilaTheHog
· Latest post 19 hours ago
by Solla-topee
0Helpful
32Views
After Spectrum updated to "High-Split" the Deco app speed test reports full bandwidth (~600mbs) but my computer, connected via Ethernet, only reports ~100mbs. Same for other computers connected via Wi
0Helpful
64Views