2 x C225 with Different firmware?
Hey, I have a selection of TAPO cameras, inside and outside.
Yesterday, I got a notification for a new firmware update available for one of two C225 I have, both version 1.0. while the other does not see a new firmware update?
1 - C225 is 1.0.27 Build 231107 Release 69776n (doesnt see an update)
2 - C225 is 1.0.28 Build 231214 Release 69164n (updated yesterday)
Tied all the usual, rebooting check for update etc.
Any ideas whats going on?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
For your question, you can refer to Q3 in the link below.
Common questions about the TP-Link camera's firmware
Best Regards
- Copy Link
- Report Inappropriate Content
Hi,
For your question, you can refer to Q3 in the link below.
Common questions about the TP-Link camera's firmware
Best Regards
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi,
Since we roll out the new firmware gradually, it's reasonable to see that some cameras detect and update to the new firmware, but some do not, if your cameras have the same model number and hardware version.
Don't worry the cameras with the old firmware version won't update, please wait patiently, and you can update the firmware on the Tapo app once the new firmware has been pushed to the cameras.
Best Regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 224
Replies: 3
Voters 0
No one has voted for it yet.