I have the ER605 trying to work as a router off the SB8200 cable modem. It goes down daily, and struggles to come back up without a full cycle reset. I recently enabled the 2nd wan port, Wan/Lan1, and

I have two identical ER605V1 routers. Both with the identical beta firmware load, both running off Docker based Linux Controllers which are both 5.9.31. Both have dynamic DNS setups at freedns-afraid-

This Article Applies to: ER605 v1 _1.3.0_Build 20230511 (Adapted to Omada SDN Controller v5.8) Release Notes: New Feature/Enhancement: 1. Add stateful ACL. 2. Add mDNS Repeater . 3. Add support for se

Hello! I'm trying to setup an isolate VLAN network that can only get to the internet but not to anything else on the network. I have a TP Link SG2428P switch. On the switch, I have ports 2-4 setup as

I have just installed a fairly simple Omada system at a client's house. BT Fibre Modem -> ER7206 Router -> POE Switch with APs and an OC200 controller. The system is repeatedly going offline, pretty m

Hey TP-Link Community, a couple of months ago I upgraded from a 50MBIT/s fiber connection to a 300MBIT/s connection. With that Upgrade I also had to get a better Switch because my previous one was onl