After updating and migrating my TL-SG2424P to Software Omada SDN v4.4.4 i enabled Service -> SNMP to access remote PoE status via SNMP. Unfortunately I have no write access. If i try to set PoE state

When I analyze the EAP225 wifi signal before connecting I can see that the 5ghz is almost at -90dBm - so low. I am testing two 5g adapters - pc and usb. I can move the usb to get a stronger signal fro

WARNING: If you setup a second LAN (or more), and isolate it via ACL, then the router remains accessible on the new network(s)..! I setup the Router address to 192.168.1.1/24 and created 2 additional

Is it possible to enable Jumbo Frames / adjust MTU for an Omada controlled switch? I'm using an OC200 with a couple SG2210MP switches and it looks like it's not able to handle jumbo frames. Trying pin

We are using for while now TL-SG2210P and TL-SG2008P as POE-PD's with POE-trough on a Juniper EX4200-48PX. As the Juniper is quite old and it would be nice to have all switch in Omada we wanted to rep

Hi guys, Which one is better in terms of signal coverage? EAP265 HD or EAP620 HD. I tried to compare on the TP-Link website and I found: EAP265 HD antenna types: Internal Omni • 2.4 GHz: 3× 3.5 dBi