I have an er605 that i would like to be able to set static routes on, however I am unable to set a static 0 route on the wan interface. If I use another device to run DHCP i can get the router to work

It appears at some point my ER605 got caught in an adopting / provisioning loop. Everything kept working so I didnt notice an issue until the controller docker crashed and restarted it. Every few minu

I'm trying to open port 123 for my cameras vlan so the cameras can use NTP. I created an ACL rule but it's not working and I'm assuming i'm doing something wrong or going about it the wrong way. Any s

This Article Applies To: EAP610-outdoor V1 Fully Adapted to Omada SDN Controller v6.1 or above; EAP620 HD V3 Fully Adapted to Omada SDN Controller v6.1 or above; EAP660 HD V2 Fully Adapted to Omada SD

Hi, I built a network of Omada Devices, with one Gateway, 3 switches, 1 Controller and 5 EAPs. Now my intention was to get wifi/internet to an appartment which can be reached by the wifi of EAP650-Out

Claro's LINK on WAN1 or WAN2 only works at the lowest speed. NIO's link works perfectly on any port. ER605 V2 bug? I'm facing a very strange problem with my ER605 V2 router with firmware 2.3.0 Build 2