Urgent feature request -> Force the Infra Red state manually from the App

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Urgent feature request -> Force the Infra Red state manually from the App

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Urgent feature request -> Force the Infra Red state manually from the App
Urgent feature request -> Force the Infra Red state manually from the App
2022-09-21 22:12:14 - last edited 2022-09-23 01:05:03
Model: Tapo C110  
Hardware Version:
Firmware Version:

There is an urgent feature needed, allow disable Infra Red form the app.

 

I'm using tapo C110, tryed disabled it by removing the IR board and unplug the IR cut filter wire from the lens but the camera stll switces to a B&W "software mode".

 

The sensor is sensible enough without needing IR in low light conditions and able to use color as seen during the time it takes to swich to IR mode.

 

Please address this by adding an advanced feature to disable / enable IR manually from the APP.

 

IR is bad and need to be disabled in certain conditions like behing windows or when close surfaces reflects the IR and overexposured the image blinding all far darker objects.

  3      
  3      
#1
Options
1 Reply
Re:Urgent feature request -> Force the Infra Red state manually from the App
2022-09-22 01:33:00

  @chaveiro 

 

The camera IR led can be turned OFF by switching the AUTO Mode to Day mode on the left top of Live view page in the Tapo APP, please check this thread for details. 

https://community.tp-link.com/en/smart-home/forum/topic/256060?replyId=572872

 

Thank you for the feedback. I think we may need make an FAQ instruction for that. 

  0  
  0  
#2
Options

Information

Helpful: 3

Views: 449

Replies: 1

Related Articles