C200 was working fine, now the Tapo app can't connect
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I set up a new out of the box C200 yesterday, and it was working fine yesterday.
This morning I was able to view the camera stream from the app. I then created an 'camera account' so that I could access the stream via rstp, and that worked a couple of times, and now I can't connect to the camera at all.
I can ping it's IP address, and I can connect to its port 545, but I can no longer retrieve frames via rstp.
Has anyone else seen behaviour like this?
I should note that there is also a SD card in the camera.
Any suggestions?
Is there a way to set the MTU on the camera? It is in the garage, and is connecting through a wifi repeater, but I am getting a solid 6 MBps upload and download in the garage, and as I stated, ping works fine, even when I crank up the packet size to it's max of 1472?
