Forums/
Deco
2023-08-22 01:56:06
@BlueGrits Hi, welcome to the community. I think you might need to adjust the network topology a little bit, such as: Spectrum cable modem=> Main Deco X90 => Netgear hub (GS208) => multiple wired...
1HELPFULS
Forums/
Range Extenders
2023-08-22 01:15:13
@Steph0273 Hi, Have you tried to run a factory reset on RE300 first by holding the reset pinhole for 1s till all the lights turn on and then off? After that, please try to set it up again to see...
0HELPFULS
Forums/
Deco
2023-08-21 08:56:41
@Cabuzzi Hi, Did you mean the 2.4 GHz band of Guest was only 25m/s out of 100m/s bandwidth from the Deco? Frankly speaking, it is not too bad. There are only 11 channels available for 2.4ghz and...
0HELPFULS
Forums/
Deco
2023-08-21 05:40:35
@JromeM Hi, welcome to the community. Deco X90 does not support POE and currently, Deco X50-POE and Deco X50-Outdoor are able to utilize POE. Thank you very much. Best regards.
0HELPFULS
Forums/
Deco
2023-08-21 03:48:51
@heynowjerry Hi, welcome to the community. Deco W7200-V1 with the latest firmware 1.2.2 does not yet support VPN server/client features. As for the printer server, have you already got a plan for how...
0HELPFULS
Forums/
Deco
2023-08-21 02:04:04
@mikekorrivo Hi, have you ever configured a static IP address on the printer before working with the old router? It it suggested to check the current IP addresses on both the printer and laptop to...
0HELPFULS