Solution Motion Detection Stops Working in the Scrypted App or NVR After Updating the Tapo Cam's Firmware
Motion Detection Stops Working in the Scrypted App or NVR After Updating the Tapo Cam's Firmware
This Article Applies to:
Tapo C100 V1/V2
Tapo C200 V1/V2
TC60 V1/V2
TC70 V1/V2
Phenomenon Description:
After updating the firmware of the Tapo Camera to version 1.3.5/1.3.6, the motion detection feature is functioning as expected when managing the camera via the Tapo app. However, it's not working anymore on the NVR or the Scrypted App that connects to the camera via the ONVIF stream.
Workaround:
Update the camera's firmware to the latest version and check if that helps.
How to update the firmware of the Tapo devices on the Tapo App
It's recommended to start a new thread here with the following information for further assistance.
1. Camera's model number, hardware, and firmware version.
2. A description of the phenomenon you encounter.
More Articles:
How to view the Tapo camera on PC through the RTSP stream?
How to Setup Tapo Wireless Camera with VIGI NVR?
>> Smart Home: Introduction to Common Smart Action Scenarios for Tapo Cameras
>> Tapo Camera Day/Night Mode Selection Guide: Best Settings Recommendations for Different Scenarios
>> Enhance Your Tapo App Experience: Introduction to Several Practical Features
>> Troubleshooting for Tapo Camera's Privacy Mode Automatic Activation
