Tapo D230 Doorbell doesn't record for length of time requested
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Model is a D230, not a D230S1 which is the only doorbell listed in the model drop-down.
Settings are:
Event detected wake up
Motion, person, package, car detection sensitivity is set to 10
Recording schedule is set to event detected
Working mode is high performance
Auto power saving mode is off
No detection zones are set
Video quality is set to 2k 5MP
The hub has a 256GB branded memory card in it and is not close to full
All my recordings are 13-17 seconds long. A lot the recordings stop whilst there is someone or a car actively moving in the frame which should not happen.
Is there a setting I've obviously missed? In the beginning I'm sure I was getting far longer and accurate videos than this.
At the moment I cannot figure out what is wrong, there's either some misconfiguration which I'm struggling to find or I'm thinking the hardware is faulty.
Any help much appreciated, thank you 🙏
