Beta Software Deco X50/X55_V1.3_1.3.1 Introduced Channel Selection, WiFi Access Control and WireGuard VPN
Re:Deco X50/X55_V1.3_1.3.1 Introduced Channel Selection, WiFi Access Control and WireGuard VPN
I've used a three-pack of X55's with the new firmware in router mode but they have a strange bug where the two nodes only connect to the main deco at 5ghz. After a few reboots they connect at both 2,4ghz and 5ghz but after a short while they fall back to only 5ghz.
The signal strength is always weak when only connected to the main node at 5ghz, even with the node in the same room as the main Deco. They seem to work fine though.
I also have a Deco M5 connected but removing it doesn't seem to make a difference.
Re:Deco X50/X55_V1.3_1.3.1 Introduced Channel Selection, WiFi Access Control and WireGuard VPN
Hi, it is also recommended to help me submit the Deco App log here:How to submit Deco APP log
Can I also have some screenshots of the network map on the Deco App, such as:
Wait for your reply.
Best regards.
▶Check What's Currently Going on With Deco
▶Deco X50_V1_1.8.0 Significantly Expanded the Client Connection Details and Added Channel Selection
▶Deco X50/X55_V1.3_1.3.1 Introduced Channel Selection, WiFi Access Control and WireGuard VPN
▶Deco BE65_V2_1.2.10 New Firmware with Enhanced Stability & Interference Resistance
▶Deco BE75 1.1.0 Added WireGuard VPN, Manual Channel Selection and More
Try to leave a Message if urgent help is required.
