Home

Forums

Stories

Knowledge Base

Smart Home Community > Tapo Smart Camera > Tapo C200 can't reset

< Tapo Smart Camera

Tapo C200 can't reset

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2023-11-18 15:20:41

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-11-18

Tapo C200 can't reset

2023-11-18 15:20:41

Model: Tapo C200

Hardware Version: V3

Firmware Version:

Hi I got problem with my tapo c200. I got three of them. But on one I can not to reset. Any advice?

I plug in power it start red light and also night vision lamps after few seconds red light start to blink night vision still on.

I press reset button for 5 seconds but it all the same. Camera do not start blinking red/green. So I can connect in app.

Thx.

1 Reply

2023-11-20 11:42:11

Posts: 13167

Helpful: 2259

Solutions: 1847

Stories: 8

Registered: 2020-05-19

Re:Tapo C200 can't reset

2023-11-20 11:42:11

Hi,
Please ensure the reset operation has been done correctly.
How to reset my Tapo camera?

Then you can refer to Case 3 in the link below to troubleshoot, and if the problem remains, you can contact the retailer or the local support to check if your camera is under warranty.
What to do if my Tapo Camera gets bricked or doesn't respond to a factory reset?

Best Regards