Smart Home Community > Tapo Smart Camera > detection error
< Tapo Smart Camera

detection error

detection error

detection error
detection error
Yesterday
Tags: #Motion Detection #Tapo Care #Device Sharing #Recording
Model: Tapo C246D  
Hardware Version: V1
Firmware Version: 1.1.3 Build 260108 Rel.58200n

The camera has developed a problem. The settings were set to automatically reboot every night, and after the next reboot, the camera started sending continuous notifications every three minutes about detecting a stationary vehicle. This problem never happened before, but it started yesterday. Reducing the sensitivity to 1-2 units helps, but then the camera starts missing passing vehicles.Help me

  0      
 
  0      
 
#1
Options
3 Reply
Re:detection error
15 hours ago

  @EvilZone62 Even reducing sensitivity doesn't help. Stationary vehicles now constantly receive a "vehicle detected" notification.

  0  
  0  
#2
Options
Re:detection error
5 hours ago

  @EvilZone62 repeat. 

detects the vehicle after automatic reboot
  0  
  0  
#3
Options
Re:detection error
2 hours ago

  @EvilZone62 

Hi,
You can refer to the following instructions to troubleshoot the reported phenomenon. It's recommended to contact the technical support team if you need further assistance.
What should I do if my Tapo camera triggers false detection?
Best Regards

>> Smart Home: Introduction to Common Smart Action Scenarios for Tapo Cameras >> Tapo Camera Day/Night Mode Selection Guide: Best Settings Recommendations for Different Scenarios >> Enhance Your Tapo App Experience: Introduction to Several Practical Features >> Troubleshooting for Tapo Camera's Privacy Mode Automatic Activation
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 44

Replies: 3

Tags

Motion Detection Tapo Care Device Sharing Recording
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.