KL125 Not Resetting Config After 5 power cycles

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

KL125 Not Resetting Config After 5 power cycles

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Zepheniah

2023-03-20 06:48:37

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-03-20

KL125 Not Resetting Config After 5 power cycles

2023-03-20 06:48:37

Tags: #Feature Request #Smart Actions #Remote Control

I have new broadband service and can't reset the configuration of my KL125 bulbs. After cycling power 5 times, the bulbs (4) don't respond. Is there another way to force the bulb to reset it's configuration?

They just remain on and can't be seen when attempting to add a new KL100 series bulb on the Kasa app.

1 Reply

Riley_S

2023-03-20 16:15:42

Posts: 3004

Helpful: 882

Solutions: 117

Stories: 39

Registered: 2022-04-18

Re:KL125 Not Resetting Config After 5 power cycles

2023-03-20 16:15:42

@Zepheniah,

The Power Cycling is the official way to reset these devices. I would recommend making sure that you wait a short time between each power cycle so that the devices are able to start their boot-up process.

FAQ: How to Reset Your TP-Link Smart Bulb

After a successfully reset, the light should flash or have an indicator that the device has been reset and is now in setup mode. This behavior must be seen before trying to add the devices to the Kasa App.

Check out the Latest: Getting Started with EasyMesh and TP-Link New Tablet Mode for the Tapo App Comparing the Latest Tapo Doorbells

KL125 Not Resetting Config After 5 power cycles

KL125 Not Resetting Config After 5 power cycles

Information

Voters 0

Tags